Thaiadmin

การ upload ไฟล์ ios image ด้วย xmodem (cisco 2950 series)

0 สมาชิก และ 1 บุคคลทั่วไป กำลังดูหัวข้อนี้

Athena_Shield

การ upload ไฟล์ ios image ด้วย xmodem (cisco 2950 series)
« เมื่อ: 8 สิงหาคม 2005, 12:59:40 »
The example below shows an Xmodem procedure on a 2955 using Hyperterm.
The procedure is the same for a 2950 or 3550.

Begin by issuing the command copy xmodem: flash: filename on the switch, as shown below.

switch: copy xmodem: flash:c2955-i6q4l2-mz.121-13.EA1.bin
Begin the Xmodem or Xmodem-1K transfer now...
CCC

  • From the pull-down menu at the top of the Hyperterm window, select Transfer, then Send File.



  • Choose the Xmodem protocol in the Send File dialog box. Use the Browse button to select the IOS image (.bin file) you downloaded previously.



  • Press Send to begin the Xmodem transfer.


The Xmodem file transfer begins. This may take up to two hours, depending on the size of the image.

CCCCCCC.........................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
.............................................................................
File "xmodem:" successfully copied to "flash:c2955-i6q4l2-mz.121-13.EA1.bin"
� � � � � � � � � �


!--- If the Xmodem file transfer fails for whatever
!--- reason, restart the process.
!--- If the Xmodem file transfer is successful,
!--- you are returned to the switch: prompt.

� � � � � � � � � � �
switch:
Boot the new image you just copied over using the Xmodem procedure. Issue the boot flash: filename command, as shown below.

switch: boot flash:c2955-i6q4l2-mz.121-13.EA1.bin
Loading "flash:c2955-i6q4l2-mz.121-13.EA1.bin"...###############################
################################################################################
� � � �

--- output suppressed ---


Press RETURN to get started!
Switch>
� � � � � � � �

!--- Bootup was successful.


Make sure to verify that your boot statements are set correctly.


ข้อมูลจาก

� � � Recovering Catalyst 2950 ... from a Corrupted or Missing Image
� � � http://www.cisco.com/warp/public/473/192.html




« แก้ไขครั้งสุดท้าย: 6 กันยายน 2005, 04:41:22 โดย Aegis In The Dark. »